![]() To look up further, google "GRBL Error Code for more information. More than one g-code command from same modal group found in block.įeed rate has not yet been set or is undefined.Įrror codes 23-38 all give different reasons for a file failing. This usually means that you used the wrong Post-Processor to make your file, or that some incompatible code within needs to be manually deleted. Unsupported or invalid g-code command found in block. File most likely formatted improperlyīuild info or startup line exceeded EEPROM line length limit. Soft limits cannot be enabled without homing also enabled. G-code commands are locked out during alarm or jog state. Grbl ‘$’ command cannot be used unless Grbl is IDLE. Move to the last 2 highlighted items and change the values to what you want up to the limit of your machine. Auto-restoring affected EEPROM to default values. If you are using GRBL 1.1 then you should make sure Laser Mode Enable is set to 1 Then you may need to change the X Axis Maximum rate and the Y Axis Maximum rate. Homing is not enabled via settings.Īn EEPROM read failed. Negative value received for an expected positive value. Grbl ‘$’ system command was not recognized or supported. Missing the expected G-code word value or numeric value format is not valid G-code words consist of a letter and a value.
0 Comments
Leave a Reply. |